Is The Elder Scrolls IV: Oblivion Remastered built on Unreal Engine 5, and how does that affect requirements?

The Elder Scrolls IV: Oblivion Remastered (2025) was rebuilt by Virtuos in Unreal Engine 5, layered over the original Gamebryo simulation engine. This dual-engine architecture means the game runs two stacks simultaneously — the original Oblivion logic and the UE5 renderer — which is why system requirements are higher than the visual output alone might suggest. Nanite and Lumen are used for geometry and lighting. The UE5 layer adds shader compilation overhead typical of the engine; allowing the built-in PSO pre-compilation to complete before your first session is important to prevent hitching during gameplay. Despite being a remaster, the CPU requirements reflect a modern UE5 game rather than a 2006 classic.

Does Oblivion Remastered support DLSS and FSR, and is it needed?

Oblivion Remastered supports NVIDIA DLSS 3, AMD FSR 3, and Intel XeSS. Given the UE5 overhead and Lumen global illumination, upscaling is recommended for any GPU below a score of 90 to maintain 60 FPS at 1080p on high settings. DLSS Quality mode on an RTX 3080 or better delivers near-native image quality with a meaningful frame rate uplift. FSR 3 Quality is recommended for AMD users in the RX 7700 XT class. The Cyrodiil open world is where GPU load peaks — walled cities like Imperial City with Lumen-lit interiors and exteriors simultaneously active are the most demanding scenarios. Interior spaces like Ayleid ruins and Imperial forts are significantly less demanding.

Can I Run The Elder Scrolls IV: Oblivion on RX 7700 XT?

The Elder Scrolls IV: Oblivion FPS Benchmark and Performance Analysis

GPU: AMD Radeon RX 7700 XTGame: The Elder Scrolls IV: OblivionUpdated: Mar 30, 2026

For most players, AMD Radeon RX 7700 XT is a solid match for The Elder Scrolls IV: Oblivion. Expect around 193 FPS at 1080p high, with strong high-refresh potential. The Elder Scrolls IV: Oblivion can behave very differently depending on settings and GPU headroom. This estimate shows where AMD Radeon RX 7700 XT lands and how to tune it for smoother gameplay.

The Elder Scrolls IV: Oblivion FPS Benchmarks on RX 7700 XT

Resolution	Settings Preset	Avg FPS	1% Low FPS	Verdict
1080p	Competitive (Low)	241 FPS	160 FPS	Excellent
1080p	High	193 FPS	128 FPS	Excellent
1440p	High	143 FPS	91 FPS	Very Good
1440p	Ultra	107 FPS	68 FPS	Good
4K	High	89 FPS	53 FPS	Good

Benchmarks are estimated by our performance engine. Actual results may vary.

Not your CPU?Run this benchmark with your own CPU pre-loaded and see your exact frame rate.

Try with my CPU →

Best Settings for The Elder Scrolls IV: Oblivion on RX 7700 XT

310+FPS1080p Competitive

Display Mode: Fullscreen
Resolution: 1920×1080
V-Sync: Disabled
Texture Quality: High
Shadow Quality: High
Anti-Aliasing: TAA
Effects Quality: High
Post-Processing: Medium
Ambient Occlusion: Enabled

Performance Analysis

At 1080p high, our model places AMD Radeon RX 7700 XT near 193 FPS in The Elder Scrolls IV: Oblivion. At 1440p, that typically translates to around 143 FPS with similar quality targets. This places the card in the mid tier for this title, with a esports ready experience profile. AMD Radeon RX 7700 XT is esports-ready for The Elder Scrolls IV: Oblivion at 1080p, and remains comfortable at 1440p with tuned settings.

The Elder Scrolls IV: Oblivion is a classic RPG that pioneered many impressive open-world concepts, drawing heavily on CPU logic to simulate radiant NPC lives. To meet the minimum system demands, your PC should have a 128MB Direct3D compatible video card and DirectX 9.0 compatible driver. For optimal performance and smooth rendering, it’s recommended to play with a ATI X800 series, NVIDIA GeForce 6800 series, or higher.

AMD Radeon RX 7700 XT supports FSR 3 with Fluid Motion Frames in compatible titles. When The Elder Scrolls IV: Oblivion supports FSR 3, Fluid Motion Frames can significantly boost the perceived frame rate on top of the base estimate shown above.

Enable low-latency mode and cap FPS close to your monitor refresh for steadier frame pacing.
Ray tracing can be enabled with quality upscaling for a good visual/performance balance.
For esports play, keep visual clutter low and prioritize visibility-focused presets.
1440p: High settings, use Quality upscaling only if needed

AMD Radeon RX 7700 XT lands in a esports ready position for The Elder Scrolls IV: Oblivion. Dialing in the right preset makes a noticeable difference at this performance level.

Frequently Asked Questions

Is The Elder Scrolls IV: Oblivion Remastered built on Unreal Engine 5, and how does that affect requirements?: The Elder Scrolls IV: Oblivion Remastered (2025) was rebuilt by Virtuos in Unreal Engine 5, layered over the original Gamebryo simulation engine. This dual-engine architecture means the game runs two stacks simultaneously — the original Oblivion logic and the UE5 renderer — which is why system requirements are higher than the visual output alone might suggest. Nanite and Lumen are used for geometry and lighting. The UE5 layer adds shader compilation overhead typical of the engine; allowing the built-in PSO pre-compilation to complete before your first session is important to prevent hitching during gameplay. Despite being a remaster, the CPU requirements reflect a modern UE5 game rather than a 2006 classic.
Does Oblivion Remastered support DLSS and FSR, and is it needed?: Oblivion Remastered supports NVIDIA DLSS 3, AMD FSR 3, and Intel XeSS. Given the UE5 overhead and Lumen global illumination, upscaling is recommended for any GPU below a score of 90 to maintain 60 FPS at 1080p on high settings. DLSS Quality mode on an RTX 3080 or better delivers near-native image quality with a meaningful frame rate uplift. FSR 3 Quality is recommended for AMD users in the RX 7700 XT class. The Cyrodiil open world is where GPU load peaks — walled cities like Imperial City with Lumen-lit interiors and exteriors simultaneously active are the most demanding scenarios. Interior spaces like Ayleid ruins and Imperial forts are significantly less demanding.